Что рекомендуется делать после погружения?

Быстрый ответ

After each dive: 1) Rinse with fresh water, 2) Dry thoroughly, 3) Inspect for damage, 4) Apply dielectric grease to O-rings, 5) Store in dry environment. 10-minute routine extends connector life 3x.

Post-Dive Maintenance Steps

Step 1: Fresh Water Rinse (2 minutes)

• Rinse entire connector assembly
• Focus on threads and mating surfaces
• Use low-pressure fresh water

Step 2: Drying (3 minutes)

• Pat dry with lint-free cloth
• Use compressed air for hard-to-reach areas
• Ensure no moisture in pin cavities

Step 3: Inspection (2 minutes)

• Check O-rings for nicks or deformation
• Inspect pins for corrosion
• Look for housing damage

Step 4: Lubrication (2 minutes)

• Apply thin layer of dielectric grease to O-rings
• Light coating on threads
• Avoid getting grease on electrical contacts

Step 5: Storage (1 minute)

• Store in protective caps
• Keep in dry environment
• Avoid direct sunlight

Свяжитесь с нами

Maintenance guides: support@hysf-connect.com